HOOK-UP AND OPERATION INSTRUCTIONS FOR ECONO PHOTOCELL

DESCRIPTION

This is a photocell timer module, which is installed in an Ammo Box. Module timer is capable of feeding once or twice a day. This timer operates on a 12-Volt DC Gel Cell battery.

CONNECTION (This has been done for you)

Connect the red battery wire to the "POS." + Battery Screw Terminal Board and the black wire to the "NEG" – Battery Screw Terminal board. Hook the " POS." red motor wires to the " POS." + Motor Screw Terminal Board and the "NEG" - black motor wire to the "NEG"- Motor Screw terminal Board. CAUTION! DANAGE TO CIRCUIT WILL RESULT IF CONNECTED IMPROPERLY AND LEFT IT WILL EVENTUALLY BURN UP YOUR CIRCUIT. When the controller is first hooked to a battery it sometimes runs the motor twice. This is normal. Be sure and keep the heat shrink protective covers over the hook-up terminals on the motor wires. These terminals have been installed to make it easy to remove your module with out tools if you wish to remove the module or if it needs service.

OPERATION INSTRUCTIONS

On the Control Unit are two controls, a switch marked 1 and 2 and a variable resistor marked INCREASE. The varaiable resistor is used to control the "on" time of the motor. Turned counter clockwise (more time). And clock-wise less time. This allows the operator to set the "on" time for approximately two to twenty-four seconds.

The 1 – 2 switch allows the operator to select one operation (in the morning) with the switch in the number 1 position, or twice (morning and evening) with the switch in the number 2 position.

ADJUSMENTS

After the controller is hooked-up and has settled out. It looks at light. Cover the small hole with your hand or dark cloth or paper. The light sensor is behind the hole. The electronic filter in the controller causes an operation delay of about thirty seconds to one minute. The motor will operate after the delay. Remove your hand or cover and the motor will operate again after the delay. Two operations will occur only if the controller is on 2 operations. Two things control the amount of feed out; the run time on the controller and the distance the spinner is set from below the opening of the feed shoot. A distance of 5/8” is usually adequate. The operator can adjust the two for the amount of feed out desired.

SOLAR PANEL HOOK UP

Connect the spade terminals to the binding posts on the side of the container.

GOOD HUNTING!

Top